Electronic Parking Brake (Frana De Mana) si Auto-Hold

[AnNemic]

Poate nu am facut eu corect, basic settings, sau nu inteleg exact ce trebuie facut. Am citit pe RossTech, dar imi puteti explica mai exact ce presupune basic settings? Eu am facut un "Functional test" ca si basic settings

 

[AnNemic]

Open Rear Parking Brake - Done

 Asteptat 30s -> Motor Oprit

 Pornit Motor

Close Rear Parking Brake - Done

Function Test  - Done

 

 

 

Longitudinal Acceleration Sensor (G251)

Prerequisites:

System voltage at least 12.0 V.
 

[Select]
[03 - Brake Electronics]
[Measuring Blocks - 08]
Group 004
[Go!]
Check field 4, the value has to be between -1.5 and +1.5 m/s².  - Done
[Done, Go Back]
[Close Controller, Go Back - 06]   

[53 - Parking Brake]
[Basic Settings - 04]
Group 020
[Go!]
Activate the Basic Setting. 
[ON/OFF/Next]  -> Apare ON , am asteptat 1 minut insa nu se schimba nimic in casute (prima are 0.0 parca, celelalte 3 au N/A) . Ce fac gresit?
The status of the Longitudinal Acceleration Sensor (G251) is now being displayed.
[Done, Go Back]
To make sure the basic setting was successful, check the sensor again.
[Close Controller, Go Back - 06]

[03 - Brake Electronics]
[Measuring Blocks - 08]
Group 004
[Go!]
Check field 4, the value has to be between -2.5 and +2.5 m/s².
[Done, Go Back]
[Close Controller, Go Back - 06]

[AnNemic]

Update: Problema rezolvata cu ajutorul lui Valentin Cucu. A fost nevoie de schimbare codare pe ABS - probabil un BUG -.

[Al Bundy]

Si ce codare ai acum pe ABS ?